I have trimmed down the ClamAV to just a few files and am going to run it on a schedule to a couple machines. I then want to run a job that will take the virusscan log and feed it into my database and parse out any problems.

Right now here is my command line.

C:\ClamAV\Clamscan -d c:\Clamav\database -l c:\virusscan.log -i -r c:\

But after it runs I get a log that has all the "Can't open file" and "Empty File" errors. I don't care. I just want the list of viruses if it gets infected. If I am clean I dont' want anything in that log file except 0 (Zero) viruses found.

C:\ClamAV\Clamscan -d c:\Clamav\database -l c:\virusscan.log -i -r --infected c:\

That should do it.