Hello guy I just have basic question on how to set-up ClamAV
here are my question:
1- Proxy setting can be added if needed in the file /etc/clamav/freshclam.conf By adding the following Information.

How do I get the information I being asked on this tutorial for does two setting?
2. When I start the Program from the first time I window pop-up and asked to do this:
Edit ---> freshclam.conf -------> Clamd.conf
Under /etc ----------> please edit before attempting signature update
How do i open in terminal command /etc
(what terminal code do I have to use to update the program)

can you please help me out whit my setting please?
Thank you very much for stopping by to help me out


oem@freekbox:~$ ifconfig
eth0 Link encap:Ethernet HWaddr 00:11:0a:a4:1e:22
inet addr:192.168.1.102 Bcast:192.168.1.255 Mask:255.255.255.0
inet6 addr: fe80::211:aff:fea4:1e22/64 Scope:Link
UP BROADCAST RUNNING MULTICAST MTU:1500 Metric:1
RX packets:28854 errors:0 dropped:0 overruns:0 frame:0
TX packets:15855 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:1000
RX bytes:35317632 (33.6 MB) TX bytes:1917434 (1.8 MB)
Interrupt:20

lo Link encap:Local Loopback
inet addr:127.0.0.1 Mask:255.0.0.0

This is the ClamWin forum is for users of the Windows GUI port of ClamAV. You may get some help with Clam AV at https://www.clamav.net/support/ on the web.

Regards,